LED Whip Installation Guide

Important Notes

Professional installation recommended.
Test LED Whips and wiring prior to installation.

Overview:

Our Bushdoof LED Whips are designed for quick, straightforward installation, featuring a quick release base and simple wiring to integrate with brake lights, indicators, or other accessories. Follow this guide to seamlessly install and configure your whips.

What you'll need:

• Drill with 10mm drill bit (if required)
• 19mm spanner/socket
• Electrical tape
• Zip ties
• Multimeter (optional)
• Vehicle manual (for reference)
• 5Ah inline fuse recommended

Step 1: Mount the Whip Base

• Check packaging contents, you should have:
  - 2x Bushdoof LED Whips
  - 2x Quick Release Bases
  - Controller & Wiring
  - Extension wires
• Drill a 10mm hole if necessary to mount the whip base.
• Tighten using a 19mm spanner/socket.
• Attach the LED Whip to the base via the quick release mechanism.

 

Step 2: Prepare & Route Wiring

• Mount the supplied controller securely, preferably in a dry, protected location.
• Connect positive (red) and negative (black) wires from controller to a 12V source via switch or battery.
• Use a 5Ah inline fuse on the positive wire for safety.
• Refer to wiring diagram below to connect additional functions such as indicators and brake lights if desired.
• Secure wiring neatly using zip ties and avoid heat sources or sharp edges.

 

Step 3: Final Test & Configure

• Test all wiring connections and ensure whips are functioning before final fitment.
• Open the Bluetooth app and select the RGB controller.
• Rename the controller and group it with other Bushdoof products if desired.

 

Wiring Diagram:

Tech Specs:

 

Downloads:

• Bushdoof Control App (iOS)
• Bushdoof Control App (Android)
• Troubleshooting Guides